ILLEGAL CHOPPING CONDITION (Cause, )

1. The chopping axis is in the servo-off or removed status. 2. The chopping axis is the rotating axis, basic axis or tilting axis under tilt control, or tandem axis. 3. The top dead point and the bottom dead point are the same. 4. The chopping axis has not been returned to its zero point. 5. An attempt was made to start chopping when the chopping axis is selected for the axis to control manually. 6. The chopping feed rate is zero. 7. An attempt was made to change the chopping axis during chopping. 8. An attempt was made in the replay mode of the fixed offset method to use an offset number of which record has not been written. 9. An M-code command for axis movement is issued during chopping.

1. 1Press the RESET key.
2. 2Take action below against respective causes described above.
3. 31.
4. 4Ensure that the chopping axis is not in the servo-off or removed status.
5. 52.
6. 6Select an axis other than the rotating axis, basic axis or tilting axis under tilt control, or tandem axis for the chopping axis.
7. 73.
8. 8Review the position of the top dead point or bottom dead point.
9. 94.
10. 10Return the chopping axis to its zero point.
11. 115.
12. 12Select another axis for an axis to control manually and start chopping.
13. 136.
14. 14Review the chopping feed rate setting.
15. 157.
16. 16Do not change the chopping axis during chopping.
17. 178.
18. 18Use an offset number of which recording is finished in the replay mode of the fixed offset method.
19. 199.
20. 20Do not issue any M-code command for axis movement during chopping.