ILLEGAL CYCLE START (Alarm No., )
It was attempted to start automatic operation under the following conditions: Alarm No. | Cause --- | --- 0 × 101 | The smoothing level is not zero. 0 × 102 | NC ready signal is not ON. 0 × 103 | Reset state not yet cleared. 0 × 104 | Feed hold is in operation. 0 × 105 | Hardware overtravel not yet cleared. 0 × 106 | Software overtravel not yet cleared. 0 × 107 | No operation mode selected. 0 × 108 | Two or more operation modes selected. 0 × 109 | During change in operation modes. 0 × 110 | During editing on the EIA MONITOR display. 0 × 111 | During search on the tape data. 0 × 113 | Abnormality in temperature. 0 × 114 | Program being edited on the EIA MONITOR display 0 × 115 | A door opened. 0 × 116 | During compensation in tandem control. 0 × 117 | An alarm related to polygonal machining or hob milling not yet cleared. 0 × 118 | An alarm related to safety barrier not yet cleared. 0 × 120 | After establishing absolute positions through zero return operation, the power has not been turned off and back on.
- 1Remove the cause, if possible, to (re)start the automatic operation.
- 2If not, contact the nearest Mazak Technical Center or Technology Center.