CANNOT USE CUTTING PT CTRL (WNo., NNo., BNo.)

1. In the mode in which a cutting point command cannot be specified, a cutting point command was specified. 2. A cutting point command was specified although a workpiece coordinate system was selected as the coordinate system for programming. 3. A cutting point command was specified although the shape offset is processed by sifting the coordinates (F161 bit1 = 0). 4. A circular interpolation command was specified although cutting point command mode or a table coordinate system was selected.

1. 1Take action below to remove the cause, and press the RESET key or tap the alarm clear button.
2. 21.
3. 3In the cutting point command mode, check other selected modes and cancel those that cannot be used.
4. 42.
5. 5If a G43.9 command is specified in the state a workpiece coordinate system is selected as the coordinate system for programming, specify a G43.8 command or select a table coordinate system for the programming coordinate system.
6. 63.
7. 7Set F161 bit1 = 0 to specify a cutting point command.
8. 84.
9. 9Specify a G43.8 command or select a workpiece coordinate system for the programming coordinate system.