‹ALARMSMazatrol Assistant
G-CODEEIA/ISO · modal · group 01
G00

Positioning

Machine-specific. This G-code reference is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (EIA/ISO programming manual H747PB0030E). G-code availability depends on fitted options, and groups and behaviour differ between Mazak models and control generations — verify against the manual for your own machine before programming with any code.
What it does

Positioning command G00 involves use of a coordinate word. This command positions a tool by moving it linearly to the ending point specified by a coordinate word. Highly accurate positioning free from any backlash error can be performed when the axis movement is controled by the G60 command so that the final access always takes place in one determined direction.

G00 is modal (group 01) — it stays in effect until another code of the same group replaces it.

Initial state: a parameter can select G00 as the initial modal condition — what your machine wakes up in depends on that setting.

Programming format
G00 Xx Zz   ; ( denotes an additional axis, that is, B-, C- or Y-axis)
Address words
  • Where x, z and  denote a coordinate.
  • The command addresses are valid for all additional axis.
  • G60 Xx Zz ; (: Additional axis)
Source

Mazak PROGRAMMING MANUAL for EIA/ISO PROGRAM, manual H747PB0030E, section 6-1 Positioning: G00, p. 3-11, 6-1, 6-2, 6-3, 6-4, 6-65. Reference and explanation only — not a reproduction of the manual.

Not sure how to use it? Ask the Mazatrol assistant →