G-CODEEIA/ISO · no group listed
G10.9
Selection between diameter and radius data input
Machine-specific. This G-code reference is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (EIA/ISO programming manual H747PB0030E). G-code availability depends on fitted options, and groups and behaviour differ between Mazak models and control generations — verify against the manual for your own machine before programming with any code.
What it does
The G10.9 command allows changeover between diameter data input and radius data input, facilitating the creation of the turning section in a compound machining program. Positioning command G00 involves use of a coordinate word. This command positions a tool by moving it linearly to the ending point specified by a coordinate word.
The list prints no group for this code.
Programming format
G10.9 A _ x
Address words
- A : Address of the axis for which diameter or radius data input is to be specified.
- x
- Numerical value = 0: Radius data input
- 1: Diameter data input
- 3. Remarks
- 1. Give the G10.9 command in a single-command block. Otherwise it may be ignored.
- 2. If the G10.9 command is not followed by an axis address, the alarm 807 ILLEGAL
- FORMAT is caused. Also, the alarm 806 ILLEGAL ADDRESS is caused if a rotational axis
- is specified in the G10.9 command.
- 3. Do not assign a decimal point to the numerical value that follows the axis address. Moreover,
- assigning a value other than 0 and 1 results in the alarm 809 ILLEGAL NUMBER INPUT.
- 4. The G10.9 command only changes the method of programming the positional data for the
- particular axis. It does not affect various external data such as parameters, workpiece origin
- data, tool data, and tool offset data.
Source
Mazak PROGRAMMING MANUAL for EIA/ISO PROGRAM, manual H747PB0030E, section 5-5 Selection between Diameter and Radius Data Input: G10.9, p. 3-11, 5-8, 5-10, 6-1. Reference and explanation only — not a reproduction of the manual.