Transverse cut-off cycle

Q: What does Mazak G-code G275 do?

G275 — Transverse cut-off cycle on the MAZATROL SmoothX control (INTEGREX e-670H). This function is used for smooth disposal of machining chips in transverse cut-off machining. This allows easy disposal of machining chips in face turning as well.

Q: What is the programming format of G275?

G275 Re ; G275 X_ Z_ P_ Q_ Rd F_ S_ T_ ; G275 executes cycle operaitons as shown below. A P e Q d z x TEP144’

Machine-specific. This G-code reference is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (EIA/ISO programming manual H747PB0030E). G-code availability depends on fitted options, and groups and behaviour differ between Mazak models and control generations — verify against the manual for your own machine before programming with any code.

What it does

This function is used for smooth disposal of machining chips in transverse cut-off machining. This allows easy disposal of machining chips in face turning as well.

G275 is modal (group 09) — it stays in effect until another code of the same group replaces it.

Programming format

G275 Re ;
G275 X_ Z_ P_ Q_ Rd F_ S_ T_ ;
G275 executes cycle operaitons as shown below.
A
P
e
Q
d
z
x
TEP144’

Address words

Unit: mm

Source

Mazak PROGRAMMING MANUAL for EIA/ISO PROGRAM, manual H747PB0030E, section 13-6-6 Transverse cut-off cycle: G275, p. 3-11, 13-67, 13-68, 13-69, 13-70, 13-76, 13-77, 13-78, 13-79. Reference and explanation only — not a reproduction of the manual.

Not sure how to use it? Ask the Mazatrol assistant →