PARAMUser parameter · POINT (D)
D1
Height of the second R-point during point machining
Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.
What it does
Height of the second R-point during point machining
The height of the R-point during point machining is basically D41, however, it is changed to D1 under the following conditions. Tool sequence Conditions Bit 6 of parameter D91 is set to 1 (D1 valid). There is a spot drill in the pre-machining tool Bit 2 of parameter D92 is set to 1 (D1 valid). There is a chamfering cutter in the pre-machining tool sequence of the same However, when a drill is included in the pre-machining tool sequence in case of a drilling tool sequence, the height is changed to D42. (D42)
Setting
Setting range–999 to 999
Unit0.1 mm/0.01 in
Program typeM
Takes effectImmediate
Source
Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 19, 103. Reference and explanation only — not a reproduction of the manual.