‹ALARMSMazatrol Assistant
PARAMUser parameter · POINT (D)
D107

POINT bit settings (4 bits)

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.
Bit settings — D107 is set bit by bit
  1. bit 1

    Fixed value

  2. bit 2

    Alarm output when 3D coordinate conversion mode cancel is specified in the manual program unit

    When a 3D coordinate conversion mode cancel code (G69 for machining centers and G69.5 for turning centers) is specified in the manual program unit, alarm 714 ILLEGAL SEQUENCE DATA is: 0: Not output 1: Output

    Range 0, 1 · Takes effect: At power on

  3. bit 3

    Unit of feed rate for the feed per minute command in manual program units for the inch system

    0 : 0.01 [in/min] 1 : 1 [in/min]

    Range 0, 1 · Takes effect: Immediate

  4. bit 4

    Calculation method for mill spindle speed when spot chamfering

    0: Calculating based on C-SP and NOM- in the tool sequence (conventional operation) < With mm specification > Mill spindle speed (min–1) = Surface speed (m/min)  1000 / (Nominal diameter (mm)  ) < With inch specification > Mill spindle speed (min–1) = Surface speed (ft/min)  12 / (Nominal diameter (in)  ) 1: Calculating based on C-SP in the tool sequence and the diameter at the cutting position (NOM-  (1/2)) < With mm specification > Mill spindle speed (min–1) = Surface speed (m/min)  1000 / (Nominal diameter (mm)  1/2  ) < With inch specification > Mill spindle speed (min–1) = Surface speed (ft/min)  12 / (Nominal diameter (in)  1/2  )

    Range 0, 1 · Takes effect: Immediate

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 23, 131, 132. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →