What is the setting range of Mazak parameter D12?

0 to 99 (unit: 0.1 mm/0.01 in). A changed value takes effect: Immediate.

PARAMUser parameter · POINT (D)

D12

Stop-hole machining hole-bottom clearance

Q: What does Mazak parameter D12 do?

D12 is a User parameter in the POINT group of the MAZATROL SmoothX control (INTEGREX e-670H). Stop-hole machining hole-bottom clearance. Element used to automatically set the hole-drilling depth during automatic tool development of stop-hole counter-boring and stop-hole boring units Example : SNo. TOOL NOM- No. HOLE- HOLE-DEP 1 DRILL 10. 10. (DEPTH – tool tip compensation – D12) Note : This parameter is invalid when the residual hole diameter is not 0.

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

What it does

Element used to automatically set the hole-drilling depth during automatic tool development of stop-hole counter-boring and stop-hole boring units Example : SNo. TOOL NOM- No. HOLE- HOLE-DEP 1 DRILL 10. 10. (DEPTH – tool tip compensation – D12) Note : This parameter is invalid when the residual hole diameter is not 0.

Setting

Setting range0 to 99

Unit0.1 mm/0.01 in

Program typeM

Takes effectImmediate

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 19, 106. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →