What is the setting range of Mazak parameter D130?

0 to 999 (unit: 0.1 mm/0.01 in). A changed value takes effect: Immediate.

PARAMUser parameter · POINT (D)

D130

Chip ejection distance in deep-hole drilling cycle

Q: What does Mazak parameter D130 do?

D130 is a User parameter in the POINT group of the MAZATROL SmoothX control (INTEGREX e-670H). Chip ejection distance in deep-hole drilling cycle. Sets the chip ejection distance for deep-hole drilling cycles. When a deep-hole drilling cycle is selected using a drill (tool sequence) with bit 0 of D141 enabled, the tool is retracted to the point determined according to the setting of D130 during machining, instead of the R-point. Note : If “0” is set, the R-point is used. [Related parameters] D106 bit 3

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

What it does

Sets the chip ejection distance for deep-hole drilling cycles. When a deep-hole drilling cycle is selected using a drill (tool sequence) with bit 0 of D141 enabled, the tool is retracted to the point determined according to the setting of D130 during machining, instead of the R-point. Note : If “0” is set, the R-point is used. [Related parameters] D106 bit 3

Setting

Setting range0 to 999

Unit0.1 mm/0.01 in

Program typeM

Takes effectImmediate

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 23, 133. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →