‹ALARMSMazatrol Assistant
PARAMUser parameter · POINT (D)
D141

POINT bit settings (3 bits)

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.
Bit settings — D141 is set bit by bit
  1. bit 0

    Chip ejection operation during deep-hole drilling cycle

    Used to select whether the chip ejection distance set for parameter D130 is to be used during deep-hole drilling cycle or not. 0: Not used (use R-point) 1: Used

    Range 0, 1 · Takes effect: Immediate

  2. bit 1

    Feed-in operation selection for deep-hole boring cycle

    Feed-in operation during deep-hole boring cycle 0 : G00 1 : G01 Note : 1. When D141 bit 1 = “0”, the G00 feed-in speed override can be set with D131. 2. When D141 bit 1 = “1”, the G01 feed-in speed can be set with F303.

    Range 0, 1 · Takes effect: Immediate

  3. bit 2

    Circular milling unit: Circular processing selection method switch

    Select the circular processing selection method for circular milling unit. 0 : Automatic selection based on “HOLE-”, “PRE-DIA” and “DEPTH” in tool sequence data of the program 1 : Circular processing B

    Range 0, 1 · Takes effect: Immediate

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 23, 134. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →