What is the setting range of Mazak parameter D16?

0 to 9 (unit: Revolutions). A changed value takes effect: Immediate.

PARAMUser parameter · POINT (D)

D16

Number of revolutions during dwell at hole bottom for chamfering cutter or spot-machining tool in chamfering cycle

Q: What does Mazak parameter D16 do?

D16 is a User parameter in the POINT group of the MAZATROL SmoothX control (INTEGREX e-670H). Number of revolutions during dwell at hole bottom for chamfering cutter or spot-machining tool in chamfering cycle. Z-axis feed dwell time at the hole bottom in the chamfering cycle of chamfering cutter or spot-machining tool. Set this time in spindle revolutions. When the chamfering cutter reaches the hole bottom, the Z-axis will firstly stop moving until the spindle makes D16 revolutions, and then return to the original position at the rapid feed rate. (Stops at hole bottom.)

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

What it does

Z-axis feed dwell time at the hole bottom in the chamfering cycle of chamfering cutter or spot-machining tool. Set this time in spindle revolutions. When the chamfering cutter reaches the hole bottom, the Z-axis will firstly stop moving until the spindle makes D16 revolutions, and then return to the original position at the rapid feed rate. (Stops at hole bottom.)

Setting

Setting range0 to 9

UnitRevolutions

Program typeM

Takes effectImmediate

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 19, 107. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →