What is the setting range of Mazak parameter D18?

0 to 9 (unit: 100 mm/min / 10 in/min). A changed value takes effect: Immediate.

PARAMUser parameter · POINT (D)

D18

Return feed rate for reaming or boring (cycle 3)

Q: What does Mazak parameter D18 do?

D18 is a User parameter in the POINT group of the MAZATROL SmoothX control (INTEGREX e-670H). Return feed rate for reaming or boring (cycle 3). The feed rate at which the tool is returned from the hole bottom during reaming or boring. Note : 1. Valid only when the setting of DEPTH for the reamer (tool sequence) is G01. 2. Valid only when the setting of PRE-DIA for the boring tool (tool sequence) is CYCLE 3. 3. If this parameter is 0, the tool is returned at the same feed rate as that of cutting.

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

What it does

The feed rate at which the tool is returned from the hole bottom during reaming or boring. Note : 1. Valid only when the setting of DEPTH for the reamer (tool sequence) is G01. 2. Valid only when the setting of PRE-DIA for the boring tool (tool sequence) is CYCLE 3. 3. If this parameter is 0, the tool is returned at the same feed rate as that of cutting.

Setting

Setting range0 to 9

Unit100 mm/min / 10 in/min

Program typeM

Takes effectImmediate

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 19, 108. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →