What is the setting range of Mazak parameter D19?

0 to 999 (unit: Revolutions). A changed value takes effect: Immediate.

PARAMUser parameter · POINT (D)

D19

Number of revolutions during dwell at hole bottom for end milling

Q: What does Mazak parameter D19 do?

D19 is a User parameter in the POINT group of the MAZATROL SmoothX control (INTEGREX e-670H). Number of revolutions during dwell at hole bottom for end milling. Z-axis feed dwell time at the hole bottom in an end milling cycle. Set this time in spindle revolutions. When the end mill reaches the hole bottom, the Z-axis will firstly stop moving until the spindle makes D19 revolutions, and then return to the original position at the rapid feed rate. (Stops at hole bottom.)

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

What it does

Z-axis feed dwell time at the hole bottom in an end milling cycle. Set this time in spindle revolutions. When the end mill reaches the hole bottom, the Z-axis will firstly stop moving until the spindle makes D19 revolutions, and then return to the original position at the rapid feed rate. (Stops at hole bottom.)

Setting

Setting range0 to 999

UnitRevolutions

Program typeM

Takes effectImmediate

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 19, 108. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →