What is the setting range of Mazak parameter D21?

0 to 99 (unit: 0.1 mm/0.01 in). A changed value takes effect: Immediate.

PARAMUser parameter · POINT (D)

D21

Reference bottom-finishing allowance for end milling

Q: What does Mazak parameter D21 do?

D21 is a User parameter in the POINT group of the MAZATROL SmoothX control (INTEGREX e-670H). Reference bottom-finishing allowance for end milling. The reference value for calculation of a bottom-finishing allowance which corresponds to the roughness level of the end milling (tool sequence). The finishing allowance in the case of roughness level 4 becomes the value of this parameter, and the values for all other roughness levels are set using the expressions listed in the table below. 6 D21 × 0.7 × 0.7 7 D21 × 0.7 × 0.7 × 0.7 8 D21 × 0.7 × 0.7 × 0.7 × 0.7 9 D21 × 0.7 × 0.7 × 0.7 × 0.7 × 0.7

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

What it does

The reference value for calculation of a bottom-finishing allowance which corresponds to the roughness level of the end milling (tool sequence). The finishing allowance in the case of roughness level 4 becomes the value of this parameter, and the values for all other roughness levels are set using the expressions listed in the table below. 6 D21 × 0.7 × 0.7 7 D21 × 0.7 × 0.7 × 0.7 8 D21 × 0.7 × 0.7 × 0.7 × 0.7 9 D21 × 0.7 × 0.7 × 0.7 × 0.7 × 0.7

Setting

Setting range0 to 99

Unit0.1 mm/0.01 in

Program typeM

Takes effectImmediate

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 19, 108. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →