What is the setting range of Mazak parameter D24?

0 to 9 (unit: Revolutions). A changed value takes effect: Immediate.

PARAMUser parameter · POINT (D)

D24

Number of revolutions during dwell at hole bottom for boring

Q: What does Mazak parameter D24 do?

D24 is a User parameter in the POINT group of the MAZATROL SmoothX control (INTEGREX e-670H). Number of revolutions during dwell at hole bottom for boring. Z-axis feed dwell time at the hole bottom in a boring cycle. Set this time in spindle revolutions. When the boring bar reaches the hole bottom, the Z-axis will firstly stop moving until the spindle makes D24 revolutions, and then the spindle orientation will be This parameter is invalid if the roughness (RGH) of the boring (tool sequence) is 0. (Stops at hole bottom.)

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

What it does

Z-axis feed dwell time at the hole bottom in a boring cycle. Set this time in spindle revolutions. When the boring bar reaches the hole bottom, the Z-axis will firstly stop moving until the spindle makes D24 revolutions, and then the spindle orientation will be This parameter is invalid if the roughness (RGH) of the boring (tool sequence) is 0. (Stops at hole bottom.)

Setting

Setting range0 to 9

UnitRevolutions

Program typeM

Takes effectImmediate

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 109. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →