What is the setting range of Mazak parameter D26?

0 to 99 (unit: 0.1 mm/0.01 in). A changed value takes effect: Immediate.

PARAMUser parameter · POINT (D)

D26

Returning distance from hole bottom for boring or back-boring

Q: What does Mazak parameter D26 do?

D26 is a User parameter in the POINT group of the MAZATROL SmoothX control (INTEGREX e-670H). Returning distance from hole bottom for boring or back-boring. The distance which the boring or back-boring tool is returned at the same feed rate and milling spindle speed as for the preceding operation after the tool has reached the hole bottom [1]Has reached the [2]Returned at the [3] Returned at a hole bottom. same feedrate. rapid feedrate. Note : Not valid if the setting for the roughness (RGH) of the boring (tool sequence) is 1.

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

What it does

The distance which the boring or back-boring tool is returned at the same feed rate and milling spindle speed as for the preceding operation after the tool has reached the hole bottom [1]Has reached the [2]Returned at the [3] Returned at a hole bottom. same feedrate. rapid feedrate. Note : Not valid if the setting for the roughness (RGH) of the boring (tool sequence) is 1.

Setting

Setting range0 to 99

Unit0.1 mm/0.01 in

Program typeM

Takes effectImmediate

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 20, 110. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →