What is the setting range of Mazak parameter D40?

0 to 9 (unit: Revolutions). A changed value takes effect: Immediate.

PARAMUser parameter · POINT (D)

D40

Number of revolutions during dwell at spot-faced hole bottom for inversed spot-facing

Q: What does Mazak parameter D40 do?

D40 is a User parameter in the POINT group of the MAZATROL SmoothX control (INTEGREX e-670H). Number of revolutions during dwell at spot-faced hole bottom for inversed spot-facing. Z-axis feed dwell time at the spot-faced hole bottom in an inversed spot facing cycle. Set this time in spindle revolutions. reaches the hole bottom, firstly the Z-axis will stop moving until the then the rotational direction of the (Feeding stops at hole bottom.)

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

What it does

Z-axis feed dwell time at the spot-faced hole bottom in an inversed spot facing cycle. Set this time in spindle revolutions. reaches the hole bottom, firstly the Z-axis will stop moving until the then the rotational direction of the (Feeding stops at hole bottom.)

Setting

Setting range0 to 9

UnitRevolutions

Program typeM

Takes effectImmediate

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 20, 113. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →