What is the setting range of Mazak parameter D42?

–999 to 999 (unit: 0.1 mm/0.01 in). A changed value takes effect: Immediate.

PARAMUser parameter · POINT (D)

D42

Height of the third R-point during point machining

Q: What does Mazak parameter D42 do?

D42 is a User parameter in the POINT group of the MAZATROL SmoothX control (INTEGREX e-670H). Height of the third R-point during point machining. The height of the R-point during point machining is basically D41, however it is changed to D42 under the following conditions. Tool sequence Conditions  Bit 6 of parameter D91 is set to 1 (D42 valid). Drill  There is a drill in the pre-machining tool  Bit 7 of parameter D91 is set to 1 (D42 valid). Chamfering  CYCLE 2 is selected for the machining  Bit 7 of parameter D91 is set to 1 (D42 valid).  CYCLE 2 in the chamfering cycle is selected

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

What it does

The height of the R-point during point machining is basically D41, however it is changed to D42 under the following conditions. Tool sequence Conditions  Bit 6 of parameter D91 is set to 1 (D42 valid). Drill  There is a drill in the pre-machining tool  Bit 7 of parameter D91 is set to 1 (D42 valid). Chamfering  CYCLE 2 is selected for the machining  Bit 7 of parameter D91 is set to 1 (D42 valid).  CYCLE 2 in the chamfering cycle is selected

Setting

Setting range–999 to 999

Unit0.1 mm/0.01 in

Program typeM

Takes effectImmediate

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 20, 114. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →