What is the setting range of Mazak parameter D44?

0, 1. A changed value takes effect: Immediate.

PARAMUser parameter · POINT (D)

D44

Selecting an automatic calculation method for the amount of chamfer with the tapping unit

Q: What does Mazak parameter D44 do?

D44 is a User parameter in the POINT group of the MAZATROL SmoothX control (INTEGREX e-670H). Selecting an automatic calculation method for the amount of chamfer with the tapping unit. Select an automatic calculation method for the amount of chamfer with the tapping unit. 0: Following calculation expression is used: (MAJOR- + 2 × PITCH) – PRE-DIA Amount of chamfer = 1: Following calculation expression is used (same as M32): Amount of chamfer = Note : Select 1 if a loss of the threaded section is likely due to overchamfering as compared with a small TAP-DEP value. Example : Sheet metal tapping

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

What it does

Select an automatic calculation method for the amount of chamfer with the tapping unit. 0: Following calculation expression is used: (MAJOR- + 2 × PITCH) – PRE-DIA Amount of chamfer = 1: Following calculation expression is used (same as M32): Amount of chamfer = Note : Select 1 if a loss of the threaded section is likely due to overchamfering as compared with a small TAP-DEP value. Example : Sheet metal tapping

Setting

Setting range0, 1

Unit—

Program typeM

Takes effectImmediate

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 20, 115. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →