What is the setting range of Mazak parameter D5?

0 to 99 (unit: 100 mm/min / 10 in/min). A changed value takes effect: Immediate.

PARAMUser parameter · POINT (D)

Prehole through speed during inversed spot-facing

Q: What does Mazak parameter D5 do?

D5 is a User parameter in the POINT group of the MAZATROL SmoothX control (INTEGREX e-670H). Prehole through speed during inversed spot-facing. The feed rate of a tool as it is being passed through the prehole during an inversed spot-facing cycle Note : 0.5 mm/rev if this parameter setting is 0.

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

What it does

The feed rate of a tool as it is being passed through the prehole during an inversed spot-facing cycle Note : 0.5 mm/rev if this parameter setting is 0.

Setting

Setting range0 to 99

Unit100 mm/min / 10 in/min

Program typeM

Takes effectImmediate

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 19, 104. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →