What is the setting range of Mazak parameter D54?

0 to 100 (unit: %). A changed value takes effect: Immediate.

PARAMUser parameter · POINT (D)

D54

Deceleration rate at cutting start for very-deep-hole drilling cycle/decremental very-deep-hole machining cycle

Q: What does Mazak parameter D54 do?

D54 is a User parameter in the POINT group of the MAZATROL SmoothX control (INTEGREX e-670H). Deceleration rate at cutting start for very-deep-hole drilling cycle/decremental very-deep-hole machining cycle. F’= F × 100 F : Specified feed rate F' : Feed rate at cutting start End point Programmed Feed rate at F' over distance  from the  = 0 (  180°)

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

What it does

F’= F × 100 F : Specified feed rate F' : Feed rate at cutting start End point Programmed Feed rate at F' over distance  from the  = 0 (  180°)

Setting

Setting range0 to 100

Unit%

Program typeM

Takes effectImmediate

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 21, 118. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →