PARAMUser parameter · POINT (D)
D66
Reduction ratio for the G00 feed rate from the chip ejection position to the return position during a deep-hole drilling/very-deep-hole drilling cycle
Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.
What it does
Reduction ratio for the G00 feed rate from the chip ejection position to the return position during a deep-hole drilling/ very-deep-hole drilling cycle
Sets the reduction ratio for the G00 feed rate used for axis travel from the chip ejection position to the return position during a deep-hole drilling/very-deep-hole drilling cycle. When either 0 or 100 is set, the feed rate is not reduced. Retraction feed rate = G00 feed rate D52 / 100 Feed rate used for axis travel from the chip ejection position to the return position = G00 feed rate D66 / 100
Setting
Setting range0 to 100
Unit%
Program typeM
Takes effectImmediate
Source
Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 21, 121. Reference and explanation only — not a reproduction of the manual.