What is the setting range of Mazak parameter DPR14?

0 to 4. A changed value takes effect: At I/O startup.

PARAMData I/O parameter · OTHER (IOP/DPR/IDD)

DPR14

Selection of an output destination port

Q: What does Mazak parameter DPR14 do?

DPR14 is a Data I/O parameter in the OTHER group of the MAZATROL SmoothX control (INTEGREX e-670H). Selection of an output destination port. The port is selected according to the combination of parameters DPR14 and DPR16. DPR16 DPR14 Port Description 2 – NC unit SIO CH1 3 – NC unit SIO CH2 When DPR14 = 4, data is output to the hard disk regardless of the DPR16 setting. Set values Output destination

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

What it does

The port is selected according to the combination of parameters DPR14 and DPR16. DPR16 DPR14 Port Description 2 – NC unit SIO CH1 3 – NC unit SIO CH2 When DPR14 = 4, data is output to the hard disk regardless of the DPR16 setting. Set values Output destination

Setting

Setting range0 to 4

Unit—

Program typeM, E

Takes effectAt I/O startup

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 100, 638. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →