LINE/FACE/3D bit settings (8 bits)

1. bit 0

   Cutting method to be used after an approach point is automatically determined during line/face machining

   0: Same operation before and after automatic determination 1: Operation by manual input after automatic determination

   Range 0, 1 · Takes effect: Immediate

2. bit 1

   Returning position during face machining

   Tool retraction position after each cutting plunge in the Z-axis direction in the face machining unit 0: R-point 1: Initial point Approach point Escape point E104 bit 1 = 1 Initial point

   Range 0, 1 · Takes effect: Immediate

3. bit 2

   Returning position during line machining

   Tool retraction position after each cutting plunge in the Z-axis direction in the line machining unit 0: R-point 1: Initial point Approach point Escape point E104 bit 2 = 1 Initial point Note : When bit 3 of parameter E95 is set to 1, “no escape on the Z-axis” is selected.

   Range 0, 1 · Takes effect: Immediate

4. bit 3

   Infeed position when a CLOSED attribute is assigned to the wall of line machining

   0: Starting or ending point of shape + Tool radius + E30 1: Starting or ending point of shape

   Range 0, 1 · Takes effect: Immediate

5. bit 4

   Method of connecting between shapes during line machining

6. bit 5

   Method of connecting between shapes during wall finish of face machining

   Select the method of connecting between shapes in line machining and wall finish of face machining. E104 (bit 4) 0 1 E105 (bit 5) 0 1 0 1 Line machining (rough, finish) Face machining (wall finish) Pattern

   Range 0, 1 · Takes effect: Immediate

7. bit 6

   Calculation of the ZC machining feed rate

   0: Calculation based on finishing surface (New scheme) 1: Calculation based on the starting position of machining (MT Pro scheme)

   Range 0, 1 · Takes effect: Immediate

8. bit 7

   Tool change command output selection

   Outputting of a tool change command when the next tool is the same tool. 0: Not output 1: Output

   Range 0, 1 · Takes effect: Immediate

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 26, 159, 160, 161. Reference and explanation only — not a reproduction of the manual.