‹ALARMSMazatrol Assistant
PARAMUser parameter · LINE/FACE/3D (E)
E106

LINE/FACE/3D bit settings (2 bits)

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.
Bit settings — E106 is set bit by bit
  1. bit 0

    Selection of the initial point as a relay point to be used after TPC approach (line/face machining unit)

    Select whether or not to go through the initial point after TPC approach relay point during line/face machining in a program of initial-point scheme. 0: Do not go through 1: Go through * Valid only with the machines equipped with ATC-type turret and swiveling-type spindle head

    Range 0, 1 · Takes effect: Immediate

  2. bit 1

    Selection of a relay point to be used before TPC escapement (line/face machining unit)

    Select the operation to perform before moving to the TPC escape relay point at the end of machining during line/face machining in a program of initial-point scheme. 0: Initial point → TPC escape relay point 1: R-point → TPC escape relay point * Valid only with the machines equipped with ATC-type turret and not equipped with swiveling-type spindle head

    Range 0, 1 · Takes effect: Immediate

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 27, 164. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →