What is the setting range of Mazak parameter E2?

0 to 999 (unit: 0.1 mm/0.01 in). A changed value takes effect: Immediate.

PARAMUser parameter · LINE/FACE/3D (E)

Cutting start point and escape point setting element (the first clearance)

Q: What does Mazak parameter E2 do?

E2 is a User parameter in the LINE/FACE/3D group of the MAZATROL SmoothX control (INTEGREX e-670H). Cutting start point and escape point setting element (the first clearance). Element used to set the cutting start point and escape point for line- or face-machining (the first clearance) Example : NOM-/2  SRV-R NOM-/2 < SRV-R start point E2 SRV-R [Applicable units]  All line-machining units  Face-machining units other than FCE MILL, TOP EMIL, and SLOT Note : 1. See the diagram of parameter E1 also. 2. Positioning of E2 at the escape point can be selected using E95, but only for line-machining units.

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

What it does

Element used to set the cutting start point and escape point for line- or face-machining (the first clearance) Example : NOM-/2  SRV-R NOM-/2 < SRV-R start point E2 SRV-R [Applicable units]  All line-machining units  Face-machining units other than FCE MILL, TOP EMIL, and SLOT Note : 1. See the diagram of parameter E1 also. 2. Positioning of E2 at the escape point can be selected using E95, but only for line-machining units.

Setting

Setting range0 to 999

Unit0.1 mm/0.01 in

Program typeM

Takes effectImmediate

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 23, 135. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →