What is the setting range of Mazak parameter E21?

0 to 999 (unit: 0.1 mm/0.01 in). A changed value takes effect: Immediate.

PARAMUser parameter · LINE/FACE/3D (E)

E21

Wall-cutting overlap in closed figure

Q: What does Mazak parameter E21 do?

E21 is a User parameter in the LINE/FACE/3D group of the MAZATROL SmoothX control (INTEGREX e-670H). Wall-cutting overlap in closed figure. The amount of overlap of the wall-cutting start and end areas in closed-pattern line- or face-machining Example: Escape point Cutting start [Applicable units]  LINE OUT, LINE IN, CHMF OUT and CHMF IN  Wall finishing of STEP, POCKET, PCKT MT, PCKT VLY and SLOT

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

What it does

The amount of overlap of the wall-cutting start and end areas in closed-pattern line- or face-machining Example: Escape point Cutting start [Applicable units]  LINE OUT, LINE IN, CHMF OUT and CHMF IN  Wall finishing of STEP, POCKET, PCKT MT, PCKT VLY and SLOT

Setting

Setting range0 to 999

Unit0.1 mm/0.01 in

Program typeM

Takes effectImmediate

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 24, 140. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →