What does Mazak parameter E96 do?

E96 is a User parameter in the LINE/FACE/3D group of the MAZATROL SmoothX control (INTEGREX e-670H). 5 bit settings.

Which bits does Mazak parameter E96 have?

Bit 1: R-point height for end milling-slot unit Bit 2: Approach method selection for 2nd and subsequent rounds of cutting in end milling-slot unit Bit 4: Approach point for 2nd and subsequent rounds of cutting in end milling-slot unit Bit 5: Returning feed rate override of the end milling-slot unit Bit 7: Smooth chamfering (end milling-slot): Switching of restrictions according to the cutting edge angle of the chamfering tool

‹ALARMSMazatrol Assistant

PARAMUser parameter · LINE/FACE/3D (E)

E96

LINE/FACE/3D bit settings (5 bits)

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

Bit settings — E96 is set bit by bit

bit 1
R-point height for end milling-slot unit
0: The R-point height is set always to E9. 1: The R-point height is set to E7 or E9 when there is or isn’t pre-machining in the same unit, respectively.
Range 0, 1 · Takes effect: Immediate
bit 2
Approach method selection for 2nd and subsequent rounds of cutting in end milling-slot unit
For the 2nd and subsequent rounds of cutting: 0: Not via the approach point 1: Via the approach point
Range 0, 1 · Takes effect: Immediate
bit 4
Approach point for 2nd and subsequent rounds of cutting in end milling-slot unit
0: Rapid feed up to the cutting allowance + E9 1: Rapid feed up to the intended surface + E9
Range 0, 1 · Takes effect: Immediate
bit 5
Returning feed rate override of the end milling-slot unit
0: Returning feed rate override of the end milling-slot unit disabled 1: Returning feed rate override of the end milling-slot unit enabled
Range 0, 1 · Takes effect: Immediate
bit 7
Smooth chamfering (end milling-slot): Switching of restrictions according to the cutting edge angle of the chamfering tool
Switching of restrictions according to the cutting edge angle of the chamfering tool used for Smooth chamfering (end milling-slot) 0: Enables machining only when the cutting edge angle is 45° (Alarm if the cutting angle edge is not 45°.) 1: Enables machining even when the cutting edge angle is not 45°. (Conventional scheme)
Range 0, 1 · Takes effect: Immediate

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 26, 156, 157. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →