‹ALARMSMazatrol Assistant
PARAMUser parameter · LINE/FACE/3D (E)
E99

LINE/FACE/3D bit settings (6 bits)

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.
Bit settings — E99 is set bit by bit
  1. bit 0

    Milling feed rate specification range for the shape sequence of the MAZATROL program

    Milling feed rate specification range for the shape sequence of the MAZATROL program 0: Valid for roughing 1: Valid for finishing

    Range 0, 1 · Takes effect: Immediate

  2. bit 1

    Bottom/wall simultaneous finishing mode for pocket machining

    Bottom/wall simultaneous finishing mode for pocket machining 0: Sequential (Conventional scheme) 1: Simultaneous

    Range 0, 1 · Takes effect: Immediate

  3. bit 3

    Interference check between the approach point and the cutting starting point of face machining

    Interference check between the approach point and the cutting starting point of face machining 0: Invalid 1: Valid

    Range 0, 1 · Takes effect: Immediate

  4. bit 4

    Alarm generating condition during the approach or escape for line machining

    Set whether or not to display alarm 705 APPROACH POINT ERROR and stop operation when the amount of tool movement is 0 for the command in the last line of shape sequence in the right-hand/left-hand linear machining or right-hand/left-hand chamfering unit. 0: Not set 1: Set

    Range 0, 1 · Takes effect: Immediate

  5. bit 5

    Smooth chamfering Stopping position during single block operation

    Used to select the stopping position while executing smooth chamfering in the single block mode. 0: Stop at any block in the chamfering path 1: Stop after completing entire circumference

    Range 0, 1 · Takes effect: Immediate

  6. bit 6

    Machining start point calculation method after automatic determination of approach point in line machining unit

    Used to select the calculation method of the machining start point after automatic determination of the approach point in line machining units. 0: Conventional scheme 1: Start machining near the automatically determined approach point

    Range 0, 1 · Takes effect: Immediate

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 26, 157, 158, 159. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →