EIA/ISO bit settings (6 bits)

1. bit 1

   Selection of table rotary axis reference position for inclined-surface machining

   Selection of table rotary axis reference position for inclined-surface machining 0: Table rotary axis start position as the reference 1: Table rotary axis 0-degree position as the reference

   Range 0, 1 · Takes effect: Immediate

2. bit 2

   Resetting of a tool life alarm with the alarm clear button

   Resetting of a tool life alarm with the alarm clear button 0: Not reset 1: Reset

   Range 0, 1 · Takes effect: Immediate

3. bit 3

   Setting a minus value for argument Q in hobbing, valid/invalid

   Setting a minus value for argument Q (module/diametral pitch) in hobbing 0: Invalid 1: Valid * If a minus value is set for argument Q in hobbing, while 0 is set for F144 bit 3, alarm 809 ILLEGAL NUMBER INPUT will be caused.

   Range 0, 1 · Takes effect: Immediate

4. bit 5

   Selection of operation by the G49 command immediately after a macro variable command

   G49 command immediately after the macro variable command when bit 3 of parameter F114 is set to 1 (no axis movement by the G49 command) 0: No axis movement 1: Axis movement

   Range 0, 1 · Takes effect: Immediate

5. bit 6

   Deletion of unnecessary codes during EIA/ISO conversion for machining centers

   G92.5 block, #3090 = 1, and G10.9 block in the EIA/ISO program converted for machining centers (parameter F30 is set to 0) 0: Output 1: Do not output Note : For G92.5 block only, the setting at bit 7 of parameter F144 is used.

   Range 0, 1 · Takes effect: Immediate

6. bit 7

   Deletion of G92.5 blocks during EIA/ISO conversion for machining centers

   G92.5 block in the EIA/ISO program converted for machining centers (parameter F30 is set to 0) 0: Output 1: Do not output * Same as when bit 6 of parameter F144 is set to 1

   Range 0, 1 · Takes effect: Immediate

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 38, 234, 235. Reference and explanation only — not a reproduction of the manual.