‹ALARMSMazatrol Assistant
PARAMUser parameter · EIA/ISO (F)
F156

EIA/ISO bit settings (8 bits)

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.
Bit settings — F156 is set bit by bit
  1. bit 0

    The operating status and the drawing on the 3D MONITOR display when a cutting command associated with rotary axis movement is specified with the automatic ISS valid

    The operating status and the switching of the drawing on the 3D MONITOR display when a cutting command associated with rotary axis movement is specified with the automatic ISS valid. Continue operation with material cutting enabled F156 bit 0 with material cutting with alarm message

    Range 0, 1 · Takes effect: Immediate

  2. bit 1

    The operating status and the drawing on the 3D MONITOR display when a cutting command associated with rotary axis movement is specified with the automatic ISS valid

    The operating status and the switching of the drawing on the 3D MONITOR display when a cutting command associated with rotary axis movement is specified with the automatic ISS valid. Continue operation with material cutting enabled F156 bit 0 with material cutting with alarm message

    Range 0, 1 · Takes effect: Immediate

  3. bit 2

    Separation between rotary axis and linear axis when moving axes during workpiece placement error correction

    Separation between rotary axis and linear axis when moving axes during workpiece placement error correction 0: Combine the movement of rotary axis and linear axis. 1 : Separate the movement between rotary axis and linear axis.

    Range 0, 1 · Takes effect: Immediate

  4. bit 3

    Selection of solution to workpiece placement error correction (primary rotary axis sign prioritized)

    Selection of solution to workpiece placement error correction (primary rotary axis sign prioritized) 0 : No priority according to the sign in the command (compliant with F162 bit 1) 1 : Priority according to the sign in the command in the program

    Range 0, 1 · Takes effect: Immediate

  5. bit 4

    Pitch division in the case when the arc length exceeds the maximum value during helical/spiral interpolation

    Pitch division in the case when the arc length exceeds the maximum value during helical/spiral interpolation 0: Invalid 1: Valid Remark : Arc length [mm] = diameter [mm]    pitch [times] Maximum arc length: 107374.1824 mm * When this parameter is invalid, alarm 814 INTERPOLATION OVERFLOW will occur if the arc length has exceeded the maximum length.

    Range 0, 1 · Takes effect: Immediate

  6. bit 5

    Single-block stop when the VFC key is pressed with override set to 100%

    Set a stop at the end of execution of a tool sequence block when the VFC key is pressed with override set to 100% during automatic operation. 0: Single-block stop does not occur 1: Single-block stop occurs

    Range 0, 1 · Takes effect: Immediate

  7. bit 6

    Fixed value (0)

  8. bit 7

    Geometric deviation compensation function, valid/invalid

    Geometric deviation compensation function 0: Invalid 1: Valid

    Range 0, 1 · Takes effect: Immediate

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 39, 241, 242. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →