EIA/ISO bit settings (8 bits)

1. bit 0

   Tool length/tool diameter check function after tool change

   Tool data check at tool length/tool radius compensation after ATC operation. 0: Invalid 1: Valid Note : 1. With F158 bit 0 = 1, if no tool data exists, the machine stops with the alarm 193 NO TOOL IN MAGAZINE generated. 2. When F158 bit 0 = 1, if no tool data has been set with the MAZATROL tool diameter data enabled (F92 bit 7 = 1) or the MAZATROL tool length data enabled (F93 bit 3 = 1), the machine stops with the alarm 1107 INCOMPLETE TOOL DATA generated.

   Range 0, 1 · Takes effect: Immediate

2. bit 1

   Output timing of MSTB command after a movement command under geometry compensation

   Output timing of MSTB command after a movement command under geometry compensation 0: Before completing axis movement 1: After completing axis movement * When an MSTB command is specified in one of the consecutive cutting feed blocks such as G1 → G1M3, the operation will be equivalent to that with F158 bit 1 = 0 and M3 will be output during movement initiated by G1 before M3.

   Range 0, 1 · Takes effect: Immediate

3. bit 2

   Display of an angle holder in the rotation direction selection menu

   Display of an angle holder in the milling tool rotation direction selection menu on the TOOL DATA display 0: Displayed 1: Not displayed

   Range 0, 1 · Takes effect: Immediate

4. bit 3

   Drawing mode of the upper and lower turrets during Y-axis turning/pinch-cutting

   Drawing mode of the upper and lower turrets during Y-axis turning/pinch-cutting 0: Drawing based on the actual axes 1: Drawing based on the virtual axes

   Range 0, 1 · Takes effect: Immediate

5. bit 4

   Distinguishing the unit number that matches the selected head by color when the compound type MAZATROL program is displayed in the process selection window

   When the compound type MAZATROL program is displayed on the process selection (restart/single block) window, the unit that matches the selected head is: 0: Not distinguished by color and displayed in black characters 1: Displayed in red characters * This parameter is valid only for the MULTIPLEX series.

   Range 0, 1 · Takes effect: Immediate

6. bit 5

   Output of an alarm when a process is selected for the head differing from the selected head in the process selection window where the compound type MAZATROL program is displayed

   When a process is selected for the head, that differs from the selected head, in the process selection window where the compound type MAZATROL program is displayed: 0: No alarm 1: Causes alarm 1477 INCORRECT PROCESS SELECTION * This parameter is valid only for the MULTIPLEX series.

   Range 0, 1 · Takes effect: Immediate

7. bit 6

   Bar loader schedule function, valid/invalid

   Bar loader schedule function 0: Invalid 1: Valid

   Range 0, 1 · Takes effect: Immediate

8. bit 7

   Selection of wear offset direction when the tool length compensation and 3D coordinate conversion functions are used together

   Select the direction in which the wear offset data of the Mazatrol tool data is applied when both the tool length compensation and 3D coordinate conversion functions are used together. 0: Actual axes (Machine coordinate system) 1: Virtual axes (Program coordinate system)

   Range 0, 1 · Takes effect: Immediate

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 40, 245, 246. Reference and explanation only — not a reproduction of the manual.