EIA/ISO bit settings (8 bits)

1. bit 0

   Timing of data creation for the MACHINING NAVIGATION - RESULT display with workpiece counting made valid

   Set the timing of data creation for the MACHINING NAVIGATION - RESULT display when “1” is specified for both CONTI. and NUMBER items of the end unit (program repetition with workpiece counting made valid). 0: At the end of the first piece machining 1: At the end of the last piece machining

   Range 0, 1 · Takes effect: Immediate

2. bit 1

   Modal selection at power on or at reset (G64/G61.1)

   Modal selection at power on or at reset 0: G64 1: G61.1

   Range 0, 1 · Takes effect: Immediate

3. bit 2

   Fixed value

4. bit 3

   Fixed value

5. bit 4

   Whether or not to display on the POSITION display a spindle output diagram stored in the setting file

   When an output diagram is displayed for continuous rating in the spindle load meter area of the POSITION display, a spindle output diagram registered in the setting file is: 0: Not displayed (An output diagram is displayed using the values set with the parameters SA67 to SA80.) 1: Displayed (An output diagram is displayed using the values stored in the setting file.) Note : This parameter is available only to models that allow the operator to switch between load meter ratings and are capable of displaying a spindle output diagram on the POSITION display.

   Range 0, 1 · Takes effect: Immediate

6. bit 5

   Workpiece spindle (C-axis) clamping speed selection in hobbing

   C-axis clamping speed selection in hobbing 0: Clamp at the rapid feed rate (parameter M1). (Conventional operation) 1: Clamp at the cutting feed rate (parameter M3).

   Range 0, 1 · Takes effect: Immediate

7. bit 6

   Reflecting tool offset (tool wear offset/tool geometry offset) in the G53.5 mode in the current position

   Reflects tool offset (tool wear offset and tool geometry offset) in the G53.5 mode in the current position in automatic operation of EIA/ISO programs: 0: Reflects 1: Does not reflect *1 This parameter is valid only for the models for which the G code type for turning machines (F30 = 1) is set. *2 Even if the setting of this parameter is changed, the current position on the TOOL PATH CHECK display and the tool nose symbol shown on the TRACE and TOOL PATH CHECK displays are given assuming the setting of F159 bit 6 = 0.

   Range 0, 1 · Takes effect: Immediate

8. bit 7

   Offset direction judgment selection for steps for workpiece measurement

   0: Compare the magnitudes of the start position and end position using signed integers. (Conventional operation) 1: Compare the magnitudes of the start position and end position using unsigned integers. * In measurement in which both of the start and end positions of the program turn out to be negative values, the result of offsetting will not be correctly reflected unless F159 bit 7 is set to “1”. This parameter is effective for steps +X, –X, +Y, and –Y in workpiece measurement.

   Range 0, 1 · Takes effect: Immediate

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 40, 247, 248. Reference and explanation only — not a reproduction of the manual.