EIA/ISO bit settings (7 bits)

1. bit 1

   Feedrate display during tool tip point control

   Set how the feedrate is displayed on the POSITION screen during tool tip point control. 0: Composite feedrate of the machine axes 1: Feedrate at the tool tip in reference to the workpiece

   Range 0, 1 · Takes effect: Immediate

2. bit 2

   Fixed value

3. bit 3

   Use of TC45 in interference check

   0: Not used 1: Used

   Range 0, 1 · Takes effect: Immediate

4. bit 4

   Display of the measured value on the AUTO MEASURE display in O.D./I.D. measurement, diameter/radius

   When the O.D./I.D. measurement is performed with the workpiece measurement unit of MAZATROL or using the workpiece measuring macro in EIA program, display mode of the target value, result of measurement and offset data on the AUTO MEASURE display is switched according to the setting for this parameter. 0: Conforms to the setting at M18 bit 5. 1: In diameter * M18 bit 5: Switching between diameter/radius (0: Radius/1: Diameter)

   Range 0, 1 · Takes effect: Immediate

5. bit 5

   Alarm output when the actual measurement of the C-axis coordinate is carried out with the sensor ON because it did not go off due to insufficient C-axis return distance after temporary measurement of the C-axis coordinate

   Alarm output when the actual measurement of the C-axis coordinate is carried out with the sensor ON because it did not go off due to insufficient C-axis return distance after temporary measurement of the C-axis coordinate 0: During continuous operation: No alarm stop During single block operation: Alarm stop 1: During continuous operation: Alarm stop During single block operation: Alarm stop

   Range 0, 1 · Takes effect: Immediate

6. bit 6

   Switching the collision check method during automatic operation with the ISS function set valid when measuring a tool by the TOOL EYE

   Switching the collision check method during automatic operation with the ISS function set valid when measuring a tool by the TOOL EYE 0: Conforms to the setting at parameter F143 bit 3 during the execution of a measuring cycle. 1: Collision check is made invalid during the execution of a measuring cycle. (During the execution of a measuring cycle means the movement starting from the “approach point” and ending at the “approach point after measurement”.)

   Range 0, 1 · Takes effect: Immediate

7. bit 7

   Priority change when erasing the tool path from the TOOL PATH CHECK display or TRACE display

   Priority when erasing the tool path from the TOOL PATH CHECK display or TRACE display 0: Drawing first After the tool path is erased, the geometry will be drawn correctly. However, the tool path erasing time will be longer than that in the case when the setting value is “1”. 1: Erasing time first The tool path erasing time will be shorter than that in the case when the setting value is “0”. However, after the tool path is erased, the color of overlapping lines may change from the one before erasure. * The drawing color differs depending on the machine.

   Range 0, 1 · Takes effect: At power on

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 40, 249, 250. Reference and explanation only — not a reproduction of the manual.