‹ALARMSMazatrol Assistant
PARAMUser parameter · EIA/ISO (F)
F165

EIA/ISO bit settings (7 bits)

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.
Bit settings — F165 is set bit by bit
  1. bit 1

    X-axis movement to minus side during polar coordinate interpolation, enabled/disabled

    Takes effect: After stop of movement

  2. bit 2

    Polar coordinate interpolation of the C-axis, in radius/diameter

    Takes effect: After stop of movement

  3. bit 3

    C-axis indexing when EIA subprogram is called from MAZATROL program

    Takes effect: After stop of movement

  4. bit 4

    Modal or non-modal state of Q command in deep-hole drilling cycle

    Takes effect: After stop of movement

  5. bit 5

    Conversion of tool set data for milling tool based on head swivel angle when G53.5 is commanded

    Takes effect: After stop of movement

  6. bit 6

    Behavior of automatic operation of an EIA program when Z-offset is not set

    Takes effect: After stop of movement

  7. bit 7

    Setting at CONTI. of the end unit during tool path check, valid/invalid

    Takes effect: After stop of movement

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 42, 258. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →