What does Mazak parameter F166 do?

F166 is a User parameter in the EIA/ISO group of the MAZATROL SmoothX control (INTEGREX e-670H). 7 bit settings.

Which bits does Mazak parameter F166 have?

Bit 0: Alteration of tool set value (tool length) on the TOOL DATA display in the automatic operation mode, enabled/disabled Bit 1: Type of wear offset indicated in the milling tool list on the TOOL DATA display Bit 2: ID No./Tool name selection on the TOOL DATA display Bit 3: Selection whether the selected plane on the TRACE or TOOL PATH CHECK display is to be held Bit 4: Operation conducted when [RESTART] is tapped following completion of the search in EIA modal restarting mode Bit 5: Tool diameter auto-setting for the end mill, face mill, and ball end mill on the TOOL DATA display Bit 7: Automatic backup function

‹ALARMSMazatrol Assistant

PARAMUser parameter · EIA/ISO (F)

F166

EIA/ISO bit settings (7 bits)

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

Bit settings — F166 is set bit by bit

bit 0
Alteration of tool set value (tool length) on the TOOL DATA display in the automatic operation mode, enabled/disabled
0: Possible 1: Impossible
Range 0, 1 · Takes effect: After stop of movement
bit 1
Type of wear offset indicated in the milling tool list on the TOOL DATA display
0: Cutting edge offset 1: Wear offset
Range 0, 1 · Takes effect: After stop of movement
bit 2
ID No./Tool name selection on the TOOL DATA display
0: IDNo. 1: Name
Range 0, 1
bit 3
Selection whether the selected plane on the TRACE or TOOL PATH CHECK display is to be held
0: Same plane 1: Retain independent plane
Range 0, 1 · Takes effect: After stop of movement
bit 4
Operation conducted when [RESTART] is tapped following completion of the search in EIA modal restarting mode
0: Retain search complete status 1: Cancel search results
Range 0, 1 · Takes effect: After stop of movement
bit 5
Tool diameter auto-setting for the end mill, face mill, and ball end mill on the TOOL DATA display
0: Automatic adjustment to nominal diameter 1: No automatic adjustment
Range 0, 1 · Takes effect: After stop of movement
bit 7
Automatic backup function
0: Invalid 1: Valid
Range 0, 1

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 42, 259, 260. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →