‹ALARMSMazatrol Assistant
PARAMUser parameter · EIA/ISO (F)
F167

EIA/ISO bit settings (8 bits)

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.
Bit settings — F167 is set bit by bit
  1. bit 0

    Threading (by turning) shift angle (Q-command) unit

    Takes effect: After stop of movement

  2. bit 1

    Handling the diameter/radius of point R during the hole-machining fixed cycle

    Takes effect: After stop of movement

  3. bit 2

    Handling the tool measured using the G137H command

    Takes effect: After stop of movement

  4. bit 3

    Handling the single-process mode when operation is completed/reset

    Takes effect: After stop of movement

  5. bit 4

    Connecting the path linearly/Alarm, if the arc internal correction value is greater than the arc radius

    Takes effect: After stop of movement

  6. bit 5

    Handling the X-axis command in G68.5

    Takes effect: After stop of movement

  7. bit 6

    Wear correction direction

    Takes effect: After stop of movement

  8. bit 7

    Updating the current position by a press of the RESET key in manual operation mode

    Takes effect: After stop of movement

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 42, 261. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →