‹ALARMSMazatrol Assistant
PARAMUser parameter · EIA/ISO (F)
F170

EIA/ISO bit settings (3 bits)

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.
Bit settings — F170 is set bit by bit
  1. bit 0

    Consideration of the offset amount of dynamic offsetting II at the current position

    Consideration of offset amount of dynamic offsetting II at the current position 0: Considered 1: Not considered

    Range 0, 1 · Takes effect: Immediate

  2. bit 2

    Tool offset changed in an EIA program in a tool path check

    Reflecting the tool offset changed in an EIA program in a tool path check 0: Does not reflect 1: Reflects

    Range 0, 1 · Takes effect: Immediate

  3. bit 3

    Continuous diameter display of the X-axis coordinates on the POSITION screen

    Continuous diameter display of the X-axis coordinates on the POSITION screen 0: Invalid 1: Valid Note : F170 bit 3 is enabled only when F82 bit 4 is set to 1. When the diameter display is enabled, the coordinates are displayed as diameter values even in the milling mode. F82 (bit 4) 0 1 F170 (bit 3) 0 1 0 1 Turning mode Radius Radius Diameter Diameter Milling mode Radius Radius Radius Diameter

    Range 0, 1 · Takes effect: Immediate

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 43, 264, 265. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →