What is the setting range of Mazak parameter F274?

0 to 999 (unit: %). A changed value takes effect: Immediate.

PARAMUser parameter · EIA/ISO (F)

F274

Cutting feedrate override rate in the tool axial direction for the EIA/ISO engraving function

Q: What does Mazak parameter F274 do?

F274 is a User parameter in the EIA/ISO group of the MAZATROL SmoothX control (INTEGREX e-670H). Cutting feedrate override rate in the tool axial direction for the EIA/ISO engraving function. Sets the ratio of the cutting feedrate in the tool axial direction with respect to the feedrate F specified in the program, used during execution of the EIA/ISO engraving function. Cutting feedrate in the tool axial direction F’ = F  F274/100 When 0 is set, 100 is assumed. If 999 or greater is set, 999 is assumed.

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

What it does

Sets the ratio of the cutting feedrate in the tool axial direction with respect to the feedrate F specified in the program, used during execution of the EIA/ISO engraving function. Cutting feedrate in the tool axial direction F’ = F  F274/100 When 0 is set, 100 is assumed. If 999 or greater is set, 999 is assumed.

Setting

Setting range0 to 999

Unit%

Program typeE

Takes effectImmediate

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 43, 267. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →