What is the setting range of Mazak parameter F303?

0 to 99999 (unit: 1 mm/min / 1 in/min). A changed value takes effect: Immediate.

PARAMUser parameter · EIA/ISO (F)

F303

G01 feed-in speed for deep-hole boring cycle M, E

Q: What does Mazak parameter F303 do?

F303 is a User parameter in the EIA/ISO group of the MAZATROL SmoothX control (INTEGREX e-670H). G01 feed-in speed for deep-hole boring cycle M, E. Sets the feed rate per minute for G01 re-entry for a deep-hole boring cycle or for G85/G285, G89/G289, G75, G76, G78, G79, G86, G88 and G89. Note : If “0” or a value outside the setting range is set, re-entry is executed at the machining feed rate.

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.

What it does

Sets the feed rate per minute for G01 re-entry for a deep-hole boring cycle or for G85/G285, G89/G289, G75, G76, G78, G79, G86, G88 and G89. Note : If “0” or a value outside the setting range is set, re-entry is executed at the machining feed rate.

Setting

Setting range0 to 99999

Unit1 mm/min / 1 in/min

Program type—

Takes effectImmediate

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 269. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →