‹ALARMSMazatrol Assistant
PARAMUser parameter · EIA/ISO (F)
F330

EIA/ISO bit settings (4 bits)

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.
Bit settings — F330 is set bit by bit
  1. bit 0

    Hobbing selection

    Switches the hobbing mode between standard hobbing and hobbing II. 0: Hobbing 1: Hobbing (position controlled hobbing)

    Range 0, 1 · Takes effect: Immediate

  2. bit 1

    Hobbing axis (V-axis) clamping speed selection in hobbing (position controlled hobbing)

    Selects the clamping speed of the hobbing axis (V-axis) in hobbing . 0: Clamping at the rapid feed rate (parameter M1) 1: Clamp at the cutting feed rate (parameter M3).

    Range 0, 1 · Takes effect: Immediate

  3. bit 2

    Machine coordinate display of hobbing axis (V-axis) and workpiece spindle (C-axis) in hobbing (position controlled hobbing)

    Selects whether to display the machine coordinates of the hobbing axis (V-axis) and workpiece spindle (C-axis) in hobbing . 0: Not displayed 1: Displayed

    Range 0, 1 · Takes effect: Immediate

  4. bit 7

    Life count for multiple tools with the same tool number and different tool names

    Counting of use count and time of use for multiple tools with the same tool number and different tool names 0: Invalid 1: Valid * This parameter is enabled when parameter F113 bit 0 = 1 (counting all types of use under the same tool number for the tool life management on the TOOL DATA display).

    Range 0, 1 · Takes effect: Immediate

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 44, 272. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →