‹ALARMSMazatrol Assistant
PARAMUser parameter · EIA/ISO (F)
F335

EIA/ISO bit settings (4 bits)

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.
Bit settings — F335 is set bit by bit
  1. bit 0

    Tool nose center speed clamp operation in the cutting point command mode

    0: Clamp at the specified speed 1: Do not clamp at the specified speed

    Range 0, 1 · Takes effect: Immediate

  2. bit 1

    Disabling linear axis distortion cancel in the 5-axis spline interpolation mode

    0: Enable cancellation of distortion for linear axes 1: Disable cancellation of distortion for linear axes

    Range 0, 1 · Takes effect: Immediate

  3. bit 2

    Disabling rotary axis distortion cancel in the 5-axis spline interpolation mode

    0: Enable cancellation of distortion for rotary axes 1: Disable cancellation of distortion for rotary axes

    Range 0, 1 · Takes effect: Immediate

  4. bit 7

    Action to take when the part count is set using the program with the INTELLIGENT SAFETY SHIELD enabled for automatic operation

    Action to take when the part count is set using the program (#3901, #3902) during automatic operation with the INTELLIGENT SAFETY SHIELD (ISS) enabled for automatic operation 0: Follow the setting of parameter F143 bit 0 (operation upon overwriting the part count during automatic operation with IIS enabled). 1: Set the part count and continue automatic operation with ISS enabled. [Related parameters] F143bit0

    Range 0, 1 · Takes effect: Immediate

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 44, 274, 275. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →