‹ALARMSMazatrol Assistant
PARAMUser parameter · EIA/ISO (F)
F336

EIA/ISO bit settings (5 bits)

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.
Bit settings — F336 is set bit by bit
  1. bit 0

    Control mode selection for rapid feed in the cutting point command mode

    Control mode for rapid feed in the cutting point command mode 0: Cutting point command mode 1: Tool center point control mode

    Range 0, 1 · Takes effect: Immediate

  2. bit 1

    Cutting point selection in a singular posture in the cutting point command mode

    Cutting point specification when the tool is set in a singular posture in the cutting point command 0: Tool tip center 1: The cutting point is made the point on the face that is closest to the immediately preceding cutting point.

    Range 0, 1 · Takes effect: Immediate

  3. bit 2

    Variable acceleration control G0

    0: Invalid 1: Valid

    Range 0, 1 · Takes effect: Immediate

  4. bit 6

    Variable acceleration control

    Variable acceleration control 0 : Invalid 1 : Valid

    Range 0, 1 · Takes effect: Immediate

  5. bit 7

    Super-high-speed machining

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 44, 275, 276. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →