EIA/ISO bit settings (8 bits)

1. bit 0

   Current position display in the G52.5 coordinate system

   Tool offset in the current position display in the G52.5 coordinate system 0: Do not consider 1: Consider * This parameter is valid for automatic operation and virtual machining, but not valid in tool path check.

   Range 0, 1 · Takes effect: Immediate

2. bit 1

   Automatic M-code setting in EIA/ISO program modal restarting mode

   M-code displayed as search results in EIA/ISO program modal restarting mode 0: Do not set automatically 1: Set automatically (up to six M-codes preceding immediately)

   Range 0, 1 · Takes effect: Immediate

3. bit 2

   Automatic S-code setting in EIA/ISO program modal restarting mode

   S-code displayed as search results in EIA/ISO program modal restarting mode 0: Do not set automatically 1: Set automatically (immediately preceding S-code)

   Range 0, 1 · Takes effect: Immediate

4. bit 3

   Error check function in cases where numerical data is omitted in the EIA program or in MDI mode

   0: Invalid 1: Valid Example : If numerical data is omitted, such as “G90G0X”, alarm 807 ILLEGAL FORMAT is displayed.

   Range 0, 1 · Takes effect: Immediate

5. bit 4

   Display of the chuck and tailstock areas for an EIA/ISO program on the TRACE or TOOL PATH CHECK display

   Whether or not the chuck and tailstock areas are to be displayed for an EIA/ISO program on the TRACE or TOOL PATH CHECK display 0: Not displayed 1: Displayed

   Range 0, 1 · Takes effect: Immediate

6. bit 5

   Touch sensor offset in X/Y direction

   Offset in the XY direction at the time when the tool offset of the touch sensor is specified by the G43P1 command (tool length compensation for a turning tool) for geometry offset X/Y on the TOOL OFFSET display 0: Invalid Only the Z-axis offset is valid. 1: Valid The X-/Y-/Z-axis offset is valid. Geometry offset Z (tool length)

   Range 0, 1 · Takes effect: Immediate

7. bit 6

   Number of effective decimal digits in the tool axis vector components (I, J, K) for tool tip point control type 2 (G43.5) and cutting point command type 2 (G43.9)

   F36 bit 6

   Range 0, 1 · Takes effect: Immediate

8. bit 7

   Rotational axis prefiltering

   0: Invalid 1: Valid

   Range 0, 1 · Takes effect: Immediate

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 29, 30, 184, 185, 186. Reference and explanation only — not a reproduction of the manual.