EIA/ISO bit settings (7 bits)

1. bit 0

   Temporary cancellation of geometry compensation for G0 (rapid traverse) in the mode of tool tip point control

   0: Invalid 1: Valid

   Range 0, 1 · Takes effect: Immediate

2. bit 1

   Subprogram call given in manual program unit (for turning machines only)

   For turning machines only: Alarming for a subprogram call command given in a manual program (MANL PRG) unit 0: No alarming 1: Alarming

   Range 0, 1 · Takes effect: Immediate

3. bit 2

   Tool length compensation in MDI operation

   Z-axis movement immediately after ATC during MDI operation when the MAZATROL tool length is valid (bit 3 of parameter F93 is set to 1) 0: Perform tool length compensation. 1: Do not perform tool length compensation.

   Range 0, 1 · Takes effect: Immediate

4. bit 3

   Timing of clearing #3006 (stop) message

   Select the timing of clearing the message that is displayed at #3006 (stop). 0: At the end of automatic operation 1: At the execution of the next block

   Range 0, 1 · Takes effect: Immediate

5. bit 4

   Selection of the coordinate system for linear interpolation on specification of a rapid traverse command during tool tip point control

   Set the coordinate system to be used for linear interpolation when a rapid traverse command has been specified during tool tip point control. 0: Table coordinate system 1: Machine coordinate system

   Range 0, 1 · Takes effect: Immediate

6. bit 5

   Operation when running programs in the hard disk or through Ethernet with the INTELLIGENT SAFETY SHIELD enabled for automatic operation

   Used to select operation when running programs in the hard disk or through Ethernet with the INTELLIGENT SAFETY SHIELD enabled for automatic operation. 0: Continue operation 1: Depend on the setting of bit 3 of parameter F35 [Related parameters] F35 bit 3

   Range 0, 1 · Takes effect: Immediate

7. bit 6

   Operation when “ATC” is not specified in end unit

   Set the operation pattern when “ATC” is not set in end unit 0: Same operation as when “1” is set for “ATC” (The tool is returned and the axes move to the returning position.) 1: Same operation as when “0” is set for “ATC” (The tool is not returned.)

   Range 0, 1 · Takes effect: Immediate

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 30, 186, 187, 188. Reference and explanation only — not a reproduction of the manual.