‹ALARMSMazatrol Assistant
PARAMUser parameter · EIA/ISO (F)
F68

EIA/ISO bit settings (2 bits)

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.
Bit settings — F68 is set bit by bit
  1. bit 0

    G53.1 acceleration selection during pre-interpolation acceleration/deceleration

    0: L74/L75 1: With modal G00, all the axes are accelerated/decelerated at the smaller of the rates for the axes set for parameters M1/N1. With modal G01, all the axes are accelerated/decelerated at the smaller rate between those for the axes set for parameters M3/N2. Note : When F68 bit 0 = 1, the composite acceleration/deceleration speed for G53.1 changes if either of the following conditions is satisfied.  G61.1 command  G61.2 command  G64 command (only for modal G00 while constant G00 inclination control is enabled)

    Range 0, 1

  2. bit 4

    Addition of tool position offset to the current position, enabled/disabled

    Addition of tool position offset to the current position 0: Added 1: Not added

    Range 0, 1 · Takes effect: Immediate

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 30, 191, 192. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →