EIA/ISO bit settings (8 bits)

1. bit 0

   Table rotational machining

   Sets the condition where machining with table rotation is possible. 0: Always possible 1: Possible outside the area only

   Range 0, 1 · Takes effect: At power on

2. bit 1

   Radial interference check

   Enables/disables radial interference check 0: Enabled 1: Disabled When 0 is set, the operation on detecting interference can be set for bit 5 of parameter F92.

   Range 0, 1

3. bit 2

   Type of coordinate system for controlling the tool tip point

   Sets the type of coordinate system for controlling the tool tip point. 0: The table coordinate system that rotates according to the particular rotation of the C-axis is defined as the programming coordinate system. 1: The work coordinate system is defined as the programming coordinate system.

   Range 0, 1 · Takes effect: Immediate

4. bit 3

   Tool tip point control scheme

   Sets the tool tip point control scheme. 0: Uni-axial rotation interpolation 1: Joint interpolation  When 0 is set: Y In the case of uni-axial rotational R2 interpolation, the pivot point of The tool attitude vector moves in a plane including R1 and R2. Tool tip Face horizontal to R1 and R2 X  When 1 is set: In the case of joint interpolation, the pivot point of the machine moves as denoted by the arrow. Tool tip X

   Range 0, 1 · Takes effect: Immediate

5. bit 4

   Fixed value (0)

6. bit 5

   Reset to cancel G68.2, valid/invalid

   Sets whether G68.2 is canceled upon pressing the RESET key. 0: Valid 1: Invalid

   Range 0, 1 · Takes effect: At power on

7. bit 6

   Display of surface definition 

   Sets whether surface definition  is to be displayed. 0 : Not displayed 1 : Displayed

   Range 0, 1 · Takes effect: At power on

8. bit 7

   Output of the B-axis unclamping code before B-axis indexing, valid/invalid

   Sets whether the B-axis unclamping code is to be output before B-axis indexing. 0: To output 1: Not to output (Valid only for MAZATROL programs of the INTEGREX and INTEGREX-e series.)

   Range 0, 1 · Takes effect: At power on

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 33, 199, 200, 201. Reference and explanation only — not a reproduction of the manual.