‹ALARMSMazatrol Assistant
PARAMUser parameter · EIA/ISO (F)
F91

EIA/ISO bit settings (8 bits)

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.
Bit settings — F91 is set bit by bit
  1. bit 0

    In response to move command without decimal point, tool moves by 1/tool moves by 10

    Takes effect: At power on

  2. bit 1

    Coordinate system shift using a MAZATROL program, valid/invalid

    Takes effect: At power on

  3. bit 2

    Stroke inside check before movement/Stroke outside check before movement

    Takes effect: At power on

  4. bit 3

    —

    Takes effect: At power on

  5. bit 4

    Metric (Initial G20 is valid/invalid)/Inch

    Takes effect: At power on

  6. bit 5

    In response to move command without decimal point:

    Takes effect: At power on

  7. bit 6

    G00 interpolation/non-interpolation

    Takes effect: At power on

  8. bit 7

    G33E command is for the number of threads per inch/command is for thread cutting with precise lead

    Takes effect: At power on

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 34, 206. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →