‹ALARMSMazatrol Assistant
PARAMUser parameter · EIA/ISO (F)
F92

EIA/ISO bit settings (8 bits)

Machine-specific. This parameter list is specific to the Mazak INTEGREX e-670H / e-670H-S with the MAZATROL SmoothX control (manual HA64HA0035E). Other Mazak models and control generations use different addresses, ranges and meanings — verify on your own control before changing anything.
Bit settings — F92 is set bit by bit
  1. bit 0

    Modal at power-on or at reset (G17 or G19/G18)

    Takes effect: At power on

  2. bit 1

    Modal at power-on or at reset (G17 or G19/G18)

    Takes effect: At power on

  3. bit 2

    Dwell command method

    Takes effect: At power on

  4. bit 3

    Tool-length compensation (G43, G44) axis for milling tools

    Takes effect: At power on

  5. bit 4

    Tool-diameter compensation (G41 or G42) start up/cancel type

    Takes effect: At power on

  6. bit 5

    Tool-diameter compensation (G41 or G42) interference check

    Takes effect: At power on

  7. bit 6

    Fixed-cycle hole-drilling axis

    Takes effect: At power on

  8. bit 7

    ACT-/NOSE-R in the TOOL DATA display for an EIA/ISO program, invalid/valid

    Takes effect: At power on

Source

Mazak PARAMETER LIST / ALARM LIST / M-CODE LIST, manual HA64HA0035E, p. 34, 207. Reference and explanation only — not a reproduction of the manual.

Not sure what to set? Ask the Mazatrol assistant →